Drash D-1000B Specifikace stáhnout pdf (Strana 23)

D-1000B Heater Operations & Maintenance

5.4.4 Removal and Installation of Fuel Filter

5.4.4.1 Removal procedures:

1. Disconnect power cord from the power source. Allow heater to cool.

2. Using a 19mm open end wrench, loosen and remove pre-heat probe from bottom of fuel filter assembly

3. Using a 10mm open end wrench, remove bolt, washer and o-ring from top of fuel filter assembly.

4. Using a suitable container, collect the fuel when removing the fuel filter assembly.

5. Remove, clean and inspect filter and discard all gaskets.

5.4.4.2 Installation procedures:

1. Install new fuel filter cartridge (76) and new O-ring from kit (75).

Figure 5-5 - Fuel Filter Assembly

2. Fill the fuel filter assembly with clean diesel fuel.

3. Place the fuel filter assembly into housing and install bolt, washer and new o-ring from kit (75).

4. Using a 10mm open end wrench, tighten the fuel filter assembly mount bolt.

5. Insert pre-heat probe into bottom of fuel filter assembly and tighten using a 19mm open end wrench.

6. Wipe up any fuel spills.

7. Connect heater to a power supply.

8. Test heater in accordance with operations manual (see Chapter 6) and check for fuel leaks.

MAINTENANCE, and REPAIR PROCE

DURES 5-7 DHS SYSTEMS LLC

No rights are conveyed except as indicated in the legend on the inside front cover of this document.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 58 59

Žádné komentáře

Drash D-1000B Specifikace Strana 23